Thanks so much Tony. Is 6020 the order number for the replacement aluminum bed?
Again, appreciate your help.
Tom
Search found 5 matches
- Tue Nov 24, 2015 12:48 am
- Forum: CNC Shark
- Topic: CNC Shark Bed
- Replies: 8
- Views: 4045
- Mon Nov 23, 2015 11:48 pm
- Forum: CNC Shark
- Topic: CNC Shark Bed
- Replies: 8
- Views: 4045
CNC Shark Bed
Hello. I have the basic CNC Shark with the wooden bed. Does anyone know if I can replace that bed with the aluminum slat beds that the other more advanced Sharks have? Thanks for any help you can provide. Appreciate it.
- Mon Nov 10, 2014 8:20 am
- Forum: CNC Shark
- Topic: Bit selection
- Replies: 3
- Views: 2807
Re: Bit selection
Thank you very much for taking the time to reply. I do appreciate it.
One last questions if I may...If you don't use tabs on a cut-out how do you anchor your cut-out piece?
Thanks again.
Tom
One last questions if I may...If you don't use tabs on a cut-out how do you anchor your cut-out piece?
Thanks again.
Tom
- Sun Nov 09, 2014 9:13 am
- Forum: CNC Shark
- Topic: Bit selection
- Replies: 3
- Views: 2807
Bit selection
Hi everyone. Just to start I am rather new at this so sorry for asking such a simple question. I am looking to create some wooden crosses for my church. About 5 inches wide and 8 inches tall. Using simple pine. I have never use my CNC Shark to cut anything out, just engraving. If I want to do a full...
- Sun Mar 23, 2014 1:26 pm
- Forum: CNC Shark
- Topic: Where to find discontinued bits
- Replies: 3
- Views: 2712
Where to find discontinued bits
Hello - I would appreciate anyone's help or ideas. Rockler no longer stocks the following Click n Carve bits. 0.25mm Conical Ball Bit for Click N Carve Tungsten Ball Nose Bit for Click-N-Carve, 0.25mm Radius I have searched high and low on the internet with no luck. If anyone knows where I might fin...