Search found 7 matches
- Wed Jan 27, 2021 8:24 pm
- Forum: CNC Shark
- Topic: Next Wave CNC Shark HD3 Accuracy Problems
- Replies: 15
- Views: 7756
Re: Next Wave CNC Shark HD3 Accuracy Problems
Sharkcutup! Your the man! Slightly different setup but vastly different numbers. Will run again using your feed rate of 75 vs my 100... I'm at 18,000rpm... Will adjust and rerun, then report back... Made adjustments to Feed Speed up/down and Spindle Speed. Unfortunately, results have not been impro...
- Wed Jan 27, 2021 5:55 pm
- Forum: CNC Shark
- Topic: Next Wave CNC Shark HD3 Accuracy Problems
- Replies: 15
- Views: 7756
Re: Next Wave CNC Shark HD3 Accuracy Problems
Sharkcutup!
Your the man! Slightly different setup but vastly different numbers. Will run again using your feed rate of 75 vs my 100... I'm at 18,000rpm...
Will adjust and rerun, then report back...
Your the man! Slightly different setup but vastly different numbers. Will run again using your feed rate of 75 vs my 100... I'm at 18,000rpm...
Will adjust and rerun, then report back...
- Wed Jan 27, 2021 2:35 pm
- Forum: CNC Shark
- Topic: Next Wave CNC Shark HD3 Accuracy Problems
- Replies: 15
- Views: 7756
Re: Next Wave CNC Shark HD3 Accuracy Problems
Attached Pictures of Results
- Wed Jan 27, 2021 2:34 pm
- Forum: CNC Shark
- Topic: Next Wave CNC Shark HD3 Accuracy Problems
- Replies: 15
- Views: 7756
Re: Next Wave CNC Shark HD3 Accuracy Problems
Attached CRV and TAP Files
- Wed Jan 27, 2021 2:32 pm
- Forum: CNC Shark
- Topic: Next Wave CNC Shark HD3 Accuracy Problems
- Replies: 15
- Views: 7756
Next Wave CNC Shark HD3 Accuracy Problems
Hi everyone! So I have had my HD3 for five years now. I have not used it much. I mainly make gifts and signs, etc. I have the latest vCarve Desktop software and the Control Panel 2.1. Anyways, I have been increasing frustrated by the quality of the cuts/finish especially in flat areas which exhibit ...
- Sun Jan 10, 2021 6:49 pm
- Forum: CNC Shark Pro Plus HD
- Topic: How to measure if the router is square to the table
- Replies: 5
- Views: 7788
Re: How to measure if the router is square to the table
Hi all. Just learning about tramming and watch the video below that showed me how to measure it without any expense. Easy peasy
https://www.youtube.com/watch?v=9h5srzEBla4
https://www.youtube.com/watch?v=9h5srzEBla4
- Mon Dec 21, 2015 11:22 am
- Forum: CNC Shark videos
- Topic: CNC Shark
- Replies: 16
- Views: 17076
Re: CNC Shark
Erick,
Which router do you have and what bits are included?
Which router do you have and what bits are included?