Search found 3 matches
- Sun Jan 14, 2018 11:11 am
- Forum: CNC Shark Pro Plus HD
- Topic: Newbie issues
- Replies: 5
- Views: 4118
Re: Newbie issues
Thanks for everyone's insight, I had to travel for work so I didn't have a chance to test these. What I found it that if I have the pendant and the computer pugged into the control unit, I received (at times) improper tool paths. I disconnected the computer and use the pendant, all is working well t...
- Wed Jan 03, 2018 4:26 pm
- Forum: CNC Shark Pro Plus HD
- Topic: Newbie issues
- Replies: 5
- Views: 4118
Re: Newbie issues
Thanks for the response. I am using the toolpaths for the Paradise Box. The first vcarve with the 60 degree bit works great, then when I switch bits to run the outer parameter vector with the 90 degree bit, it is all off.
Mike
Mike
- Wed Jan 03, 2018 11:35 am
- Forum: CNC Shark Pro Plus HD
- Topic: Newbie issues
- Replies: 5
- Views: 4118
Newbie issues
I am new to CNC so pardon my ignorance.... I purchased the Shark HD4 and have some single toolpath designs and everything went fine. Where I have an issue is when I carve a pattern with multiple toolpaths, the first toolpath works just fine but when I swap out the bit for the send and subsequent too...