Search found 4 matches
- Sat Jul 14, 2018 2:59 pm
- Forum: Setting up the Shark
- Topic: Water cooled spindle
- Replies: 19
- Views: 16387
Re: Water cooled spindle
I did not know you could CNC Aluminum on a shark...…that is soo cool !!!! must need special bits. looks like the sky is the limit, with some limitations...lol this sounds like a silly question. how do I change bits on the water cooled spindle? there does not seem to be anything to "lock" the spindle...
- Fri Jul 13, 2018 7:04 am
- Forum: Setting up the Shark
- Topic: Water cooled spindle
- Replies: 19
- Views: 16387
Re: Water cooled spindle
Hello,
I really like your setup!!!
though your set up is a little out of my league for now, hopefully in time (lots of time) I can have a set up similar to yours.
thanks again for all the great info !!!!
Guy
I really like your setup!!!
though your set up is a little out of my league for now, hopefully in time (lots of time) I can have a set up similar to yours.
thanks again for all the great info !!!!
Guy
- Thu Jul 12, 2018 12:12 pm
- Forum: Setting up the Shark
- Topic: Water cooled spindle
- Replies: 19
- Views: 16387
Re: Water cooled spindle
Hey Thom, Thank you for all the valuable info. You really went above and beyond. I will take your advice, and keep the water at room temperature, use water not 3:1 anti freeze. I like the idea of the gas can, but then I would need to get a different pump. I will think about this one....Might just us...
- Thu Jul 12, 2018 9:43 am
- Forum: Setting up the Shark
- Topic: Water cooled spindle
- Replies: 19
- Views: 16387
Re: Water cooled spindle
In reference to the Water Cooled Spindle: (I just received my water cool spindle) Is there a "cleaner" way then using a 5 gallon bucket. Does a lot of dust get in the bucket? Also, the hoses...., is there a clean way of having them run to my water supply so they do not get "hung" up? thanks in advan...