Search found 6 matches
- Sat Sep 24, 2011 11:00 am
- Forum: Shark Pro Plus
- Topic: Holders for other routers
- Replies: 24
- Views: 15258
Holders for other routers
I thought I saw at one of the web sites a holder for the Porter Cable 890 for the Shark Pro Plus but A call to Rockler indicated it was not available yet. My colt is working but I found that it gets hot at the collet and have found cutters dropping slightly making my work at times useless. I have re...
- Sat Sep 24, 2011 10:59 am
- Forum: Shark Pro Plus
- Topic: Holders for other routers
- Replies: 1
- Views: 2973
Holders for other routers
I thought I saw at one of the web sites a holder for the Porter Cable 890 for the Shark Pro Plus but A call to Rockler indicated it was not available yet. My colt is working but I found that it gets hot at the collet and have found cutters dropping slightly making my work at times useless. I have re...
- Sat Sep 24, 2011 10:43 am
- Forum: Shark Pro Plus
- Topic: Zero point setting with straight cutters.
- Replies: 4
- Views: 3413
Re: Zero point setting with straight cutters.
Good Ideas, What I do is locate the x and y then shut off the controler an turn the z down by hand to a light touch on thin paper and then trun on the controller again and it automatically sets all at zero.
George
George
- Mon Sep 19, 2011 3:00 pm
- Forum: CNC Shark
- Topic: Loss of xy 0 locations whilerunning a job
- Replies: 2
- Views: 2175
Loss of xy 0 locations whilerunning a job
Has anyone had the experience of losing the x or y zerolocation while running a program? I have had this happen a number of times and even slowing the feed or reducing cuts does notseem to help. This is on a shark Pro. Frustrating!
- Tue Jun 07, 2011 8:13 am
- Forum: CNC Shark
- Topic: Program Read Errors
- Replies: 5
- Views: 2947
Re: Program Read Errors
I brought in the correct Post Processors and put them into the PostP file as required and they do list in the PostP when looking at them in explorer but do not show up when I try and find them in the drop list in PhotVcarve. Tried rebooting everything with no change in result. I am interested in pur...
- Mon May 30, 2011 9:16 am
- Forum: CNC Shark
- Topic: Program Read Errors
- Replies: 5
- Views: 2947
Program Read Errors
Did a program in photovcarve and Coded it using G Code Inch (*.tap). When I loaded it into the Shark Pro the g codes and co-ordinates looked good. all settings were Inches. However when I started to run the machine was concentrating in a tiny area instead of the expected 4in x 2.5 in. I found that t...