CNC Shark Forum

fuse is OK, any other thoughts?

My shark just stopped running. Will not go in any direction. The green light on the power supply FS-20024-1M is off but when I disconnect the controller the little green light comes on and shows 24Volts with a meter but doesn't register voltage when the power supply is connected to the the controlle...

I did mine about 6 months ago. Next Wave had great instructions and it only took about 45 minutes to do.

A friend of mine asked if I could carve a design in his gunstock with my CNC Shark pro. I only do signs using V Carve Pro. What would I need (software & other hardware) if it is possible to do carving on gunstocks?

Thanks,
Bob Martin

Just installed my new aluminum table. It took about 1 hour. Piece of cake to do.

Just installed my new aluminum table. It took about 1 hour. Piece of cake to do.

I have a Shark pro. I live about 20miles south of Ocala. Mine has the wooden table but I have an aluminum one on order. You are more than welcome to come see it. I don't do any woodworking, the only thing I cut is HDPE (King Colorcore)

I buy my King color core from Total Plastics. I make lamppost signs for our community here in Florida. Total is a good company to work with.

Bob Martin
Martin Signs

They sent me separate ground wires to attach to each motor.

Hope this fixes the problem that I have been having.

Bob Martin

Sent overnight to the boys @ next wave. They replaced the x,y,z board shipped back to me with a retro fit (grounding wires) and I am back up & running. They were great. Thanks to Tim & his crew.

Bob Martin
Martin Graphics