Search found 5 matches

by pbscott
Thu Jun 19, 2014 6:46 pm
Forum: Show off your CNC Shark projects
Topic: Corian Carve
Replies: 9
Views: 2753

Re: Corian Carve

Nice looking plaque. Were you on a submarine?
by pbscott
Mon Sep 17, 2012 7:12 pm
Forum: CNC Shark
Topic: Swap X and Y axis
Replies: 4
Views: 2050

Swap X and Y axis

This has probably been answered before, but the layout does not make sense to me. X should be left to right. Is there a way to swap X and Y in Vectric?
by pbscott
Mon Sep 06, 2010 2:09 pm
Forum: CNC Shark
Topic: Different Y-Axis problem
Replies: 3
Views: 2267

Re: Different Y-Axis problem

Not fixed after all. It cut out correctly once, then repeated the same problem next time I tried. On the attached photo, It started at point A which was not on the file. The first pass around the outside it cut correctly at point B. Going "North" from point B, the Y axis got confused and as it progr...
by pbscott
Fri Sep 03, 2010 12:04 pm
Forum: CNC Shark
Topic: Different Y-Axis problem
Replies: 3
Views: 2267

Re: Different Y-Axis problem

Fixed! I was using the orginal post processor. When I upgraded to the PP that came with the current release of the controller (cncshark-usb_arcs_inch) it was OK.
by pbscott
Thu Sep 02, 2010 7:13 pm
Forum: CNC Shark
Topic: Different Y-Axis problem
Replies: 3
Views: 2267

Different Y-Axis problem

I am cutting out four profiles, the final one going around the perimeter of the piece cutting out the thing with a few tabs to hold it in place. It cuts in four passes each 0.2 inches deep. The first three profiles cut perfectly, but the problem is in the final profile. The first pass is fine, but s...