Search found 5 matches
- Thu Jun 19, 2014 6:46 pm
- Forum: Show off your CNC Shark projects
- Topic: Corian Carve
- Replies: 9
- Views: 4709
Re: Corian Carve
Nice looking plaque. Were you on a submarine?
- Mon Sep 17, 2012 7:12 pm
- Forum: CNC Shark
- Topic: Swap X and Y axis
- Replies: 4
- Views: 3689
Swap X and Y axis
This has probably been answered before, but the layout does not make sense to me. X should be left to right. Is there a way to swap X and Y in Vectric?
- Mon Sep 06, 2010 2:09 pm
- Forum: CNC Shark
- Topic: Different Y-Axis problem
- Replies: 3
- Views: 4028
Re: Different Y-Axis problem
Not fixed after all. It cut out correctly once, then repeated the same problem next time I tried. On the attached photo, It started at point A which was not on the file. The first pass around the outside it cut correctly at point B. Going "North" from point B, the Y axis got confused and as it progr...
- Fri Sep 03, 2010 12:04 pm
- Forum: CNC Shark
- Topic: Different Y-Axis problem
- Replies: 3
- Views: 4028
Re: Different Y-Axis problem
Fixed! I was using the orginal post processor. When I upgraded to the PP that came with the current release of the controller (cncshark-usb_arcs_inch) it was OK.
- Thu Sep 02, 2010 7:13 pm
- Forum: CNC Shark
- Topic: Different Y-Axis problem
- Replies: 3
- Views: 4028
Different Y-Axis problem
I am cutting out four profiles, the final one going around the perimeter of the piece cutting out the thing with a few tabs to hold it in place. It cuts in four passes each 0.2 inches deep. The first three profiles cut perfectly, but the problem is in the final profile. The first pass is fine, but s...