For some reason I seem to have lost the "Detect Touchplate" button in the latest version of the software (V2.1 Bld 17). I still have the "Run Virtual Setup" button and my touchplate is registered and functional. Virtual setup works fine using the touchplate. It's a problem because there's no way now to use the touchplate to set the z-axis without running the whole virtual setup.
Anybody else notice this? I'm quite sure I had the button in V2.1 Bld 16.
What happened to "Detect Touchplate"?
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 35
- Joined: Sun Jan 15, 2012 2:45 pm
Re: What happened to "Detect Touchplate"?
I would reinstall the whole thing sounds like a weird glitch maybe some corruption in the download.
By the way where on Long Island are you? Im from West babylon Clas of 78'.
By the way where on Long Island are you? Im from West babylon Clas of 78'.
Re: What happened to "Detect Touchplate"?
Problem solved. I re-registered the touchplate and voila the "Detect Touchplate" button returned. Weird because as I said I did have the "Run Virtual Setup" button which usually doesn't show up until the touchplate is properly registered.
OK, back to cutting chips.
Kevin
OK, back to cutting chips.
Kevin