8.5 Help! error messages

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
cnalley
Posts: 1
Joined: Mon Nov 18, 2013 11:10 am

8.5 Help! error messages

Post by cnalley »

err msg1.PNG
err msg1.PNG

I am getting these error messages. Vectric does not seem to help. Can someone on here help?
Attachments
errmsg 2.PNG

tonydude
Posts: 1581
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY

Re: 8.5 Help! error messages

Post by tonydude »

Why do you have the check mark on output direct to machine? Uncheck it and save the tap file to a location on your desktop, than when you open up the control panel and load file just load the tap file, that's it. Look at the tutorials
http://support.vectric.com/tutorials/V8 ... Index.html lot of help there.

Tony
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.

Post Reply