Fingermaker G Code Getting Errors loading

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: sbk, al wolford

Fingermaker G Code Getting Errors loading

Postby anyducks » Mon Nov 06, 2017 10:24 pm

I'm trying Fingermaker. It generates a G-code file. Fingermaker creates a .tap file.
When I load the tap file the following errors are generated:
Error message
"communication error - please try "load File " again

Invalid pointer operation

Error in fastdisplay. Error in displaycutimage floating point division by zero.
.

The G-code does appear in the G-code window but will not run because of the above errors.
How can i get the G-code to be save by the correct post processor, too ?

thanks
anyducks
 
Posts: 1
Joined: Tue Nov 24, 2015 12:29 am

Return to Software. Programming

Who is online

Users browsing this forum: No registered users and 1 guest