Discussion/questions about software used with your CNC Shark and programming issues

Moderators: sbk, al wolford

Post Reply
Posts: 2
Joined: Sun Sep 06, 2020 7:35 am


Post by oldpost »

Very New guy here.Got my SharkII.. all put together, Spindle works good have good movement left,right ,back and forth, up and down.
My question is the Ready2Control Software. I'm a Mac computer guy. so I have a learning curve on this PC. I go to download the Ready2 Control software
and I cant get to the portal. Any help would be appreciated.

Posts: 1
Joined: Mon Aug 17, 2020 3:29 pm

Re: Ready2control

Post by HardCastle »

This is the link to the download site:

However, you need to contact support to actually get the software. ( ) Email them with the request.


Post Reply