Control Panel install

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk

SPH01
Posts: 91
Joined: Tue Nov 01, 2011 8:35 am
Location: Gavilan Hills, CA

Re: Control Panel install

Post by SPH01 »

The extra 9pin plug will be for the 4th axis upgrade. The small round plug is for the probe upgrade.
Good luck and happy cutting

jeb2cav
Site Admin
Posts: 1527
Joined: Thu Sep 30, 2010 7:04 pm
Location: Kentucky
Contact:

Re: Control Panel install

Post by jeb2cav »

There's also a 'CNC Shark Family Owner's Manual' availabe in pdf format from the NWA Downloads page that has info like this and more in it - http://www.nextwaveautomation.com/DownLoads.aspx

amerifax
Posts: 14
Joined: Sun Dec 23, 2018 11:13 pm
Location: Germantown, WI

Diagram on Control Panel Wirers

Post by amerifax »

The diagram on Control Panel Wirers. Where can I find a diagram of the wiring?

amerifax
Posts: 14
Joined: Sun Dec 23, 2018 11:13 pm
Location: Germantown, WI

Diagram on Control Panel Wirers

Post by amerifax »

The diagram on Control Panel Wirers. Where can I find a diagram of the wiring?

Post Reply