Trouble getting shark pro pp for Cut 3D
Moderators: al wolford, sbk, Bob, Kayvon
Trouble getting shark pro pp for Cut 3D
I have the Shark Pro. I've had the program for the Cut 3d for months now and have been unable to run it on the shark. I have copied the Vcarve shark pp into the Cut 3d pp folder but it still doesn't show in the drop down when saving toolpaths of Cut 3d. Please help.
-
- Posts: 191
- Joined: Wed Aug 04, 2010 11:28 am
Re: Trouble getting shark pro pp for Cut 3D
What is the exact directory you copied the pp file to? (e.g. c:\????)
What is the name of the pp file you copied? (e.g. cncshark-usb-???)
Do you have more than one installation of Cut3D on your system? (e.g. trial and licensed both?)
Ed
What is the name of the pp file you copied? (e.g. cncshark-usb-???)
Do you have more than one installation of Cut3D on your system? (e.g. trial and licensed both?)
Ed
Re: Trouble getting shark pro pp for Cut 3D
Ed,
The pp file goes in the PostP directory under your V-Carve directory.
Here's the path on my computer:
c:\Program Files\VCarve Pro V5.0\PostP
Yours could vary slightly.
Good Luck,
Paul Fison
Tacoma, Washington
The pp file goes in the PostP directory under your V-Carve directory.
Here's the path on my computer:
c:\Program Files\VCarve Pro V5.0\PostP
Yours could vary slightly.
Good Luck,
Paul Fison
Tacoma, Washington
Re: Trouble getting shark pro pp for Cut 3D
For the Cut 3D program the correct location for the PP files are C:\Program Files\Cut3D\PostP
just load them into this sub-directory and they will show up in the PP menu
Doc
just load them into this sub-directory and they will show up in the PP menu
Doc