Page 1 of 1
Clock face
Posted: Tue Jan 08, 2013 9:07 pm
by Kevink18
How do you create a clock face in VCarve Pro.
Re: Clock face
Posted: Tue Jan 08, 2013 9:43 pm
by BillK
Here's one that I did.
Figure out your diameters based on the length of your clock hands. Then you can use the command to copy in a polar array, 12 copies in 360 degrees. Then you change each of the copies to their respective number.
Re: Clock face
Posted: Tue Jan 08, 2013 10:08 pm
by Kevink18
Thanks I really like the one you have in that clock
Re: Clock face
Posted: Wed Jan 09, 2013 2:17 am
by Wolffie1
My Valentine clock
Composite red surface and aluminium
Cheers
Wolffie
Re: Clock face
Posted: Wed Jan 09, 2013 3:29 am
by Eagle55
Here's one that I made for my sister to help her learn how to tell time. Originally I thought about just having hands that you could move manually but the more I looked at how to accomplish that I realized that I could just bolt on a AA driven movement for about $4 and be done with it, and also wind up with a fully functional clock in the process. I drew the circle and created a line from the center to the circle at the 12 o'clock position. Then copied the line around the circle 60 times. Then drew two smaller circles (one for the 5 minutes ticks and one for the minutes ticks. With all this drawn I began to selectively erase all the extra lines and then the two smaller circles leaving what was carved. I know there are better and probably easier ways to do this but this wasn't that hard and what came into my mind while drawing it.
(Cut in DuPont Corian with 90 degree bit, engraving filled with acrylic paint then polished off of surface)
Roger
PS Movement was from one of my "famous" China suppliers for about $1.99 and about $1.50 shipping. I couldn't have made a set of hands for that. BTW, doesn't come with battery for that price
ha ha ha
Re: Clock face
Posted: Wed Jan 09, 2013 8:10 pm
by Kevink18
Nice