Hi,
It's been a while that I updated my post processors. I noticed that there is already a new pp for the machine. i downloaded it and followed everything the manual says and even copied the CNCShark_run.ini to the PostP of both the vCarve Pro and Cut 3D folders respectively. vCarve Pro is working just fine, however Cut 3D shows error messages that says
Config file
Unknown statement found
On line 26 of File
c;\Program Files(X86)\Cut 3D\PostP\CNCshark-USB_New Arcs_inch.pp
DIRECT_OUTPUT = "CNCShark|CNCShark_run.ini
I tried to revert back to the original setting and reinstalled all over again. Still get the same message. I can run the program, but when I' done,I can not find the SharkPro post processor installed. Am I missing something?
Thanks in advance.
CNCShark_run.ini issues?
Moderators: al wolford, sbk, Bob, Kayvon
Re: CNCShark_run.ini issues?
Hi Peter,
Hopefully this post will answer your question and resolve the problem - http://cncsharktalk.com/viewtopic.php?f ... 6529#p6529
Hopefully this post will answer your question and resolve the problem - http://cncsharktalk.com/viewtopic.php?f ... 6529#p6529
-
- Posts: 70
- Joined: Fri Feb 11, 2011 8:42 pm
Re: CNCShark_run.ini issues?
Hi jeb2cav,
I just tried the solution found on your link. I got this problem:
DATE
Unknown variable name
On line 76 of file
C:\Programe File
(x86)\Cut3D\PostP\CNCShark-USB_3dContour_inch.pp
"( File created [DATE] - [TIME])"
The previous problem seems to disappear and was replaced by the above error. Any help?
Pete
I just tried the solution found on your link. I got this problem:
DATE
Unknown variable name
On line 76 of file
C:\Programe File
(x86)\Cut3D\PostP\CNCShark-USB_3dContour_inch.pp
"( File created [DATE] - [TIME])"
The previous problem seems to disappear and was replaced by the above error. Any help?
Pete