How to install new Post Processor

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
plascell9
Posts: 22
Joined: Sat Nov 16, 2013 9:58 am

How to install new Post Processor

Post by plascell9 »

Running VCarve Pro 7.015 and Cut3D 1.11 Next wave Automation document says I should be using CNCShark-USB_NewArcs_inch post processor. Following CNC Shark Post Processors v1.5 document, I am lost. In what sub directory does the processor file reside? Should I be looking for the CNCShark-USB_NewArcs_inch.pp filename or something else when correctly installed? I do have the file in my CNCShark directory, but if I try to do anything with it there is an "error" indication about the file.

For Cut3D it says '"unknown statement found in file On line 25 of the file C:\Programs Files\Cut3D 1.11\PostP\CnCShark-USB_NewArcs_inch.pp DIRECT_OUTPUT = "CNCShark|CNCShark_run.ini"

My CNCShark-USB_NewArcs_inch.pp file is 5.41 KB (5.544 bytes)

OS is XP SP3

My brain must not be engaged . . .

plascell9
Posts: 22
Joined: Sat Nov 16, 2013 9:58 am

Re: How to install new Post Processor

Post by plascell9 »

Part of problem seems to be that the same file is identified in mltiple ways. The file names and the title of things are not the same.

After sleeping on it, a fresh attack proved successful.

Post Reply