Touch PLate Problem ?

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
e1r9i7c9
Posts: 19
Joined: Wed Apr 06, 2011 5:14 pm

Touch PLate Problem ?

Post by e1r9i7c9 »

I buy a Touch PLate last year and I never managed to make it work. when I use the Detect Touch Plate , and I touch with the bit I can read succes and after I press yes and nothing happens. I use the version of 1.5.23h

4DThinker
Posts: 951
Joined: Wed Jun 27, 2012 9:00 am

Re: Touch PLate Problem ?

Post by 4DThinker »

If you go into settings, there are a few variables where you can set how thick the plate is among other things. I've also noticed the plate works differently if the controller is set to mm than if it is set to inches.

Post Reply