touch plate manual

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

touch plate manual

Post by gpeck »

I seem to be missing the instructions for the touch plate,so that I can use the 5 point mapping system. I can not find it the instructions that I downloaded which is for the older models 1.5 version when I bought the cnc in Nov..Are there new instructions for the 2,0? Thanks for the help.

Post Reply