I have an "interesting" problem with the virtual zero function. The setup appears fine. The system asks if I wish to load the file with virtual zero, and that appears fine. But, for the life of me, I can't tell if the virtual zero is working or not, because the system stops, and shuts itself down, about 40 lines into the job. If I reload the file, but do not use the virtual zero function, it runs fine, but of course I'm getting inconsistencies because the wood is irregular, particularly when I'm working with live edge material.
At any rate, the virtual zero functionality, which was the only reason I updated to 2.0, is just not working.
Control Panel 2.0 - incomplete jobs
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 107
- Joined: Fri Nov 08, 2013 10:03 am
- Location: Toledo, Ohio
- Contact:
Re: Control Panel 2.0 - incomplete jobs
Most likely there are I and J coordinates in the file for curves. pull down and install the updated 'v2.0 release1405-01', which fixes this issue.
-
- Posts: 107
- Joined: Fri Nov 08, 2013 10:03 am
- Location: Toledo, Ohio
- Contact:
Re: Control Panel 2.0 - incomplete jobs
2.1 [Build15] got a file parser update that should allow some of the previous non-running files to run without stopping.