I just bought SCP2 with the V0 Touchplate.
I have registered and installed everything and the plate will not detect.
I have tried everything including suggestions from NWA support.
Anybody got any ideas
Wayne @ Wayne's Woodworks
Spokane, WA.
Virtual Zero Not Detecting
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 38
- Joined: Mon Mar 12, 2012 10:06 pm
- Location: Spokane, Washington USA
- Contact:
Re: Virtual Zero Not Detecting
Once you register the plate you'll need a code to enter into then controller software. They should send it to you via the email address you used to register the machine.
-
- Posts: 38
- Joined: Mon Mar 12, 2012 10:06 pm
- Location: Spokane, Washington USA
- Contact:
Re: Virtual Zero Not Detecting
Thank u 4D but I did all that.
Techs @ NWA think the control box is bad so I shipped it to them 4 repair
No Shark for 2-3 weeks
Techs @ NWA think the control box is bad so I shipped it to them 4 repair
No Shark for 2-3 weeks