Hi,
I am looking for any information regarding using the Shark Pro Plus for PCB manufacture. I have tried using Coppercam but I cannot get it to work as I can't work out how to load the G code on to the shark control panel. If anyone has any ideas please let me know.
PCB manufacture
Moderators: al wolford, sbk, Bob, Kayvon
Re: PCB manufacture
Here is what I found, this might help you. http://www.instructables.com/id/How-to- ... on-your-C/
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
Re: PCB manufacture
Vcarve is quite capable of making PCB traces. I use a large (1/4") end mill for the large areas and a smaller bit fro the fine work. http://precisebits.com/applications/pcbtools.htm