Mach 3
Moderators: al wolford, sbk, Bob, Kayvon
Re: Mach 3
To the best of my knowledge Mach 3 is not supported on the new Sharks, even though their website says it is.
The web site issue was pointed out months ago and it still has not been corrected.
I run Mach3, (with a Smoothstepper and Gecko 540 hardware), and that replaces the whole control box.
The conversion would involve around 700 dollars in parts to build a new controller.
you can use the original motors or go up to 400 in.oz units for more power.
The web site issue was pointed out months ago and it still has not been corrected.
I run Mach3, (with a Smoothstepper and Gecko 540 hardware), and that replaces the whole control box.
The conversion would involve around 700 dollars in parts to build a new controller.
you can use the original motors or go up to 400 in.oz units for more power.
Re: Mach 3
THANKS! If I'm going to have to change steppers and the entire control, I think I will keep limping along with what I have.. but I'm disappointed in the stability, and the shark control so far...