Hey guys
I'm looking at getting a new computer and have a question. If I get a new laptop for the Shark, is it an easy switch to get the software on the new one? I don't want to have to buy a new registration, etc. Is v-carve and next wave good with the switch? I'm sure I'm not the only one this has happened to, just curious how easy the change over is.
Thanks so much in advance!
Looking at new computer
Moderators: al wolford, sbk, Bob, Kayvon
Re: Looking at new computer
The software licenses from Vectric allow install on up to three PCs, so long as they are only used by one person.
The control software is only useful on a PC connected to the CNC. NextWave doesn't care which PC that is. Re-install it on the new laptop, use your original registration codes, and you should be good to go.
The control software is only useful on a PC connected to the CNC. NextWave doesn't care which PC that is. Re-install it on the new laptop, use your original registration codes, and you should be good to go.