Tool path

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Horseshoe
Posts: 4
Joined: Sun May 31, 2015 9:08 am

Tool path

Post by Horseshoe »

I am trying to edit my tool path and have followed all of the editing steps per the manual. When I change the roughing out of a object from .2 to .1 and update it will not keep my changes. It insists on returning to the .2 depth. Why is this and how do I make it change, or can't I?
Thanks.

SnaykeByte
Posts: 7
Joined: Tue Sep 15, 2015 8:34 pm

Re: Tool path

Post by SnaykeByte »

I can't help you or I would, I'm a rookie here too. I have found this forum to be a lot of readers and not too many helpers. Good luck getting help here.

Post Reply