vectric clipart

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

vectric clipart

Post by gpeck »

I think I have v8 installed and the clipart through vectric portal an downloaded all the clipart , what I would like to know is how do I get the clip art imported ? I opened v8 and
made a 10x10 project went up to import, and all I could find were files that I had made and saved. What did do wrong?? Thanks for any info. gene

gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

Re: vectric clipart

Post by gpeck »

I found it at the bottom of the drawing page.

Eagle55
Posts: 788
Joined: Sun Nov 20, 2011 8:44 pm

Re: vectric clipart

Post by Eagle55 »

Yes they are down at the bottom in the tab labeled "clipart". When you import or open files it uses, by default the last subdirectory that you opened from. The clip art is installed in a particular directory that Vector Art chooses and you can change during installation but if you don't it goes where they suggest and the program knows where it was put.

Roger
Attachments
Fullscreen capture 8172015 15933 PM.jpg
CNC Shark HD ~ Control Panel 2.0 ~ Windows 7 & XP
Located in West Tennessee near the Tennessee River
http://www.eaglecarver4.com

Post Reply