nesting

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

nesting

Post by gpeck »

I put a group of parts together to make a project. One of the parts was a little to big to fit right so I high lighted it and made it smaller and it will cut with the other nested parts which will cut out in the nesting, but I would like to take the part that I made smaller and cut it out by itself and be able use it with the other ones that match. When I try to high lite just that part and try to calculate it a message comes up, a formula in one of the edit boxes is not valid. What does that mean?..Thanks for any Info

Post Reply