Problem transfering .tap files to memory stick

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
jimbob45
Posts: 50
Joined: Sat May 19, 2012 4:45 pm
Location: Pensacola Florida

Problem transfering .tap files to memory stick

Post by jimbob45 »

When I attempt to transfer either the .crv3d or the .tap files to a memory stick I keep getting a message that says:" this file has properties that can't be copied to the new location. If i accept to transfer it distorts the file when I try to input into my Laguna IQ HHC CNC machine.
Anyone else have this problem?
Help. Been down awhile

User avatar
bill z
Posts: 342
Joined: Fri Sep 25, 2015 9:09 am
Location: Spring, Texas USA

Re: Problem transfering .tap files to memory stick

Post by bill z »

The .tap file is a simple flat or text type of file and should transfer.

Do you have any difficulty moving your file from folder to folder on your computer?

Tell how the memory stick is formatted. Should not make a difference unless it hasn't been formatted.

Post Reply