Reinstall v8 2.0

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

Reinstall v8 2.0

Post by gpeck »

When I tried to open v 8 ths moning a box came up and said it was corrupted .

I can get 2.0 controller reinstalled but I can not get the softwawe v 8.2.0 to reinstall . I uninstalled the corupted one first

gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

Re: Reinstall v8 2.0

Post by gpeck »

If anyone is interested. I used my flash drive to copy the shortcut that is on the house cpu and tried to down load it to the cpu in the shop, would not open, was told by vectric that it should have worked, but did not.. They also said that if I could hook up too the internet I could download it from vectric portal, I did and everything seems to work ok. gene

gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

Re: Reinstall v8 2.0

Post by gpeck »

The message above I missed typing, after shortcut it should have said vectric Portal.

Post Reply