Starting in the middle of a program

[cgansel]

Is there a way to start at different places in a G code. I know you can pause and restart, but can you run part of a code without starting at the beginning?

[Buc]

You may want to read this earlier post. http://www.cncsharktalk.com/viewtopic.php?f=10&t=475.

Buc

[rapiddawg]

With the Shark controler you can not. If you want to be able to do that you need a different controler program.

[Buc]

If you want to edit G-code and create your own programs without using a CAM program, You will have to upgrade to a more complex controlled. Here is a link to check out.
http://www.machsupport.com/downloads.php
Buc