Strange line when cutting

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
tonybell9699
Posts: 48
Joined: Sun Oct 12, 2014 9:04 pm

Strange line when cutting

Post by tonybell9699 »

I have had this issue before, and with suggestions here was able to get rid of the "line" coming up in the model.

But now it is back and I am not sure what I am doing wrong, but it has ruined two very nice pieces of walnut that are now scrap.

Any ideas? i have included my setup as well.

Tony
Attachments
swo .jpg
swo 1.jpg
swo 2.jpg

Rando
Posts: 757
Joined: Tue Jan 06, 2015 3:24 pm
Location: Boise, ID
Contact:

Re: Strange line when cutting

Post by Rando »

Were you able to find the old thread and see if somehow the settings had become undone?

Does the simulator in VCarve show that errant cut?
=====================================================
ThomR.com Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)

Post Reply