in vcarve cutting a 3d on a 60" mantel on the Y axes

[gpeck]

designed a mantel that is 36x10 from 3d design and make western hack. How can I cut it out on my black diamond 24x24 table useing v carve 8.5.? I tried the tiling mode, but it will not work.Is there a way to turn the XandY axes in v carve 8,5 to cut 3d, so that the starting point is on the lower left on the Y axes ? The 3d tiling tutorials shows how in the X axes . In design and make getting started vidoes they show a wilderness hack 6 foot by 10" mantel useing v carve 8.5, but they do not show how it was cut out. Thanks for any info. gene

[Kayvon]

This is a duplicate post of this: www.cncsharktalk.com/viewtopic.php?f=15&t=5387&p=29713
And a near-duplicate of this: http://www.cncsharktalk.com/viewtopic.php?f=15&t=5384

Let's keep the discussion in those two threads.