Incomplete file load

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: sbk, al wolford

Incomplete file load

Postby airhed » Wed Jul 12, 2017 2:24 pm

Trying to run tap file from flash drive and also from computer. Shark control panel shows complete file on screen but after running virtual setup and reloading tap file, it won't load complete file. Router starts up, makes a couple moves and goes back to Zero. Its obvious when this happens because green bar stops short of loading complete file. What am I doing wrong.
airhed
 
Posts: 5
Joined: Wed Mar 16, 2016 10:53 pm

Return to Software. Programming

Who is online

Users browsing this forum: No registered users and 3 guests