3D tolpath

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

3D tolpath

Post by gpeck »

I made a 3D toolpath of the egale in the clipart in vcrave 8.5 . When I ran the program, I noticed I made a mistake , so I went back to where I ( saved as ) folder and when I opened the folder it was saved as aspire and I could not open it. It said I needed to open it using a different app. I tried vcarve pro and it said I could not use it. How can I get it to open in vcarve 8.5 of which I used to make the toolpath.??? Thanks for any info. ..... Gene

Outlaw5852
Posts: 8
Joined: Sat Apr 22, 2017 4:28 pm

Re: 3D tolpath

Post by Outlaw5852 »

I've had a similar issue. Make sure that V-Carve 8.5 has the latest update. It worked for me. Hope it does for your issue.

Post Reply