Page 1 of 1

photovcarve pp for hd4

Posted: Sun May 06, 2018 9:04 pm
by Jacduck
I have tried the add the new HD4 pp to the old pp list in photovcarve and it doesn't show up on the list. Is there a way to get the new inch pp into photovcarve?
If my grandkids or great-grandkids were here I am sure it would be easy.

Thanks jacduck

Re: photovcarve pp for hd4

Posted: Mon May 07, 2018 8:45 am
by tonydude
http://shop.nextwaveautomation.com/shop ... x?recid=26 Go down the page and download the post processor for photo v carve only. You can't use the new HD4 post processor. Also here is a pdf on how to install the post processor in photo v carve, just go down the page till u find it.

Tony

Re: photovcarve pp for hd4

Posted: Fri May 11, 2018 1:06 pm
by Jacduck
Thanks Tony but the way I read it there is not a way to use Photocarve on an HD4 since the old inch pp won't run the hd4. Am I correct?

Re: photovcarve pp for hd4

Posted: Tue May 15, 2018 4:38 pm
by tonydude
Don't know. Try it and see.

Tony

Re: photovcarve pp for hd4

Posted: Tue May 15, 2018 4:53 pm
by Rando
Post processors are not very complicated. A simple difference between one that works and doesn't is often enough to tell where the problem is.