Tiling

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
rrsnith
Posts: 26
Joined: Mon Oct 26, 2015 1:55 pm

Tiling

Post by rrsnith »

How do you keep the same zero set point when tiling. No matter how accurate I set the bit zero point on the wood the font doesn't seem to be the same.
I have tried writing down the "Z" number then going back to that number on the next tile. Sometimes its the same and others its not.
Thanks for your support.

Kevink18
Posts: 205
Joined: Fri Nov 23, 2012 3:30 pm

Re: Tiling

Post by Kevink18 »

You should only move the board z zero is already set. The only time I reset z zero is if I have to change bit for different tool path.

rrsnith
Posts: 26
Joined: Mon Oct 26, 2015 1:55 pm

Re: Tiling

Post by rrsnith »

Thanks so much

Post Reply