Please Load File
Posted: Fri Nov 23, 2018 10:05 pm
Hi,
This is my first time on the forum, so excuse me if I'm posting this question in the wrong area. I didn't see a category for troubleshooting.
I purchased the CNC Shark HD3LS Bundle a couple years ago. I have been using the machine almost daily to cut projects with no issues.
I use V-Carve Desktop to create my tap files.
I can load a tap file into the Control Panel program, it shows the program on the screen and everything appears and funtcions normally until I try to run the program.
The router spindle turns on, but the machine does not move and I get a message in the lower left corner that says "please load file." I just cut a project yesterday and nothing about the computer or the programs has changed. Also, I can manually jog all 3 axis with the program, so I don't believe it is a machine problem. Still, I'm not sure why this is happening. I'm hoping someone on here may have an answer. This problem just started today.
Thanks so much,
Jamie
This is my first time on the forum, so excuse me if I'm posting this question in the wrong area. I didn't see a category for troubleshooting.
I purchased the CNC Shark HD3LS Bundle a couple years ago. I have been using the machine almost daily to cut projects with no issues.
I use V-Carve Desktop to create my tap files.
I can load a tap file into the Control Panel program, it shows the program on the screen and everything appears and funtcions normally until I try to run the program.
The router spindle turns on, but the machine does not move and I get a message in the lower left corner that says "please load file." I just cut a project yesterday and nothing about the computer or the programs has changed. Also, I can manually jog all 3 axis with the program, so I don't believe it is a machine problem. Still, I'm not sure why this is happening. I'm hoping someone on here may have an answer. This problem just started today.
Thanks so much,
Jamie