Page 1 of 1

Pause not working

Posted: Sun Dec 02, 2018 6:16 pm
by Kevink18
I have a shark hd3 running control software 2.1 build 22 when running I the pause button is not able to be used. I have used in the past and have used it. Have not done any updates any idea

Re: Pause not working

Posted: Mon Dec 03, 2018 11:18 am
by Kayvon
I would only expect that if the link between the PC and the control panel had been dropped for some reason. The entire g-code is transferred over before cutting starts to prevent any problems that would occur if a link dropped.

Were you able to adjust the speed? I would expect that capability to have been dropped, too.

Re: Pause not working

Posted: Mon Dec 03, 2018 11:34 am
by TAW
I had this happen one time. was kind of scary, as I always start carve and hit pause with every carve. The time it did not work. I shut down the carve, powered everything down & checked all connections. after restarting everything the pause button worked again. This may work for you or you may have already tried this. good luck

Re: Pause not working

Posted: Mon Dec 03, 2018 7:44 pm
by Kevink18
E-stop on screen works speed adj works. This has happened now for the last 5 or 6 times I have turned machine on.