Supported G codes

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: sbk, al wolford

Supported G codes

Postby Efreyenhagen » Wed Apr 24, 2019 4:58 pm

Just received a FX and like it so far.

Does anyone know if there is a list of G codes supported by NWA for the FX?

What about manually entering a G code from the pendant or a computer, anyone know how this can be done?

I have a bit of experience with CNC programming, I do like the robustness of the FX based on the cost but an accustom to more flexibility than the pendant seems to provide.

any help will be greatly appreciated.

Thanks,
Ed
Efreyenhagen
 
Posts: 1
Joined: Fri Apr 19, 2019 10:59 am

Return to Software. Programming

Who is online

Users browsing this forum: No registered users and 1 guest