Does anyone know anything about Fine Line Automation and their FLA 300? Good, bad, ugly?
Thanks,
Mazzy
fine line automation FLA 300
Moderators: al wolford, sbk, Bob, Kayvon
Re: fine line automation FLA 300
As far as I know this forum is for the CNC shark and run by Rockler.
You may need a different forum for your question
Vectric Forum???
Cheers
Wolffie
You may need a different forum for your question
Vectric Forum???
Cheers
Wolffie
I am never going to die, I live in Paradise already
Re: fine line automation FLA 300
I'm confused. I thought that this part of the forum was for system comparisons. People discuss Shopbot and Sears CNC's, etc. That is all I was trying to do. Fine Line Automation has a few CNC's which I wanted a comparison on. If you want to limit discussion about competitors and their products (which I would understand), then you should not have this System Comparisons section. Because you will get discussions about competing CNC machines. And those discussions might cause a person to look elsewhere than Shark.
As a side note, I did further research on Fine Line Automation. He has a very bad rep for poor support. It's been a week and I'm still waiting for a return email from him. So Rockler and New Wave Automation should not see him as a competitive threat.
Best,
Mazzy
As a side note, I did further research on Fine Line Automation. He has a very bad rep for poor support. It's been a week and I'm still waiting for a return email from him. So Rockler and New Wave Automation should not see him as a competitive threat.
Best,
Mazzy
Re: fine line automation FLA 300
Sorry Mazzy
I wasn't ticking you off just trying to help you get more responses.
Cheers
Wolffie
I wasn't ticking you off just trying to help you get more responses.
Cheers
Wolffie
I am never going to die, I live in Paradise already