Another CNC Shark project I worked on with Woodworker's Journal http://www.woodworkersjournal.com/resou ... index.html
The web page contains the files and a PDF drawing.
Ralph
Puzzle Snack Tray
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
- Consultingwoodworker
- Posts: 333
- Joined: Fri Jul 02, 2010 7:37 am
- Location: Nashville area
- Contact:
Re: Puzzle Snack Tray
Ralph,
Another great project. Thank you for the files.
I think I'll make mine from HDPE. Possibly, even scoop it out a little to hold the snacks better. And a wine themed puzzle picture engraved into the back.
Bob
Another great project. Thank you for the files.
I think I'll make mine from HDPE. Possibly, even scoop it out a little to hold the snacks better. And a wine themed puzzle picture engraved into the back.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
- Consultingwoodworker
- Posts: 333
- Joined: Fri Jul 02, 2010 7:37 am
- Location: Nashville area
- Contact:
Re: Puzzle Snack Tray
That's the best part of what I do Bob, seeing people take my ideas and run with them! Be sure to share the results.
I'm thinking grape leaves....
Actually, I was a bit surprised to see Rob holding the six of them as a set still together! I did NOT expect that they would fit well enough for that! I created the design and wrote the program, but never cut them, just sent along the files. I knew I needed to slightly reduce the size of the pin and slightly increase the socket, but I did not think they would fit snug enough to pick up all six as a set.
Ralph
I'm thinking grape leaves....
Actually, I was a bit surprised to see Rob holding the six of them as a set still together! I did NOT expect that they would fit well enough for that! I created the design and wrote the program, but never cut them, just sent along the files. I knew I needed to slightly reduce the size of the pin and slightly increase the socket, but I did not think they would fit snug enough to pick up all six as a set.
Ralph