Packer cribbage Game Board
Posted: Mon Mar 21, 2011 9:15 am
I saw this project on the Vectric forum. http://www.vectric.com/forum/viewtopic. ... packer+fan
It was posted by Bill W. (I don't know his last name.) He was kind enough to share the file. He had used Aspire to design his version. I used VCarve 5.5 to make my version. I'm uploading the file in .eps format so that any version of VCarve can open it.
Because of copyright laws, I will exclude the letter "G" from the file. I don't know if this makes a difference or not because I will not sell this project anyway.
Just use your judgment when you make these and respect all copyright rules.
Also be careful when machining this project and check to see if all information and spelling is accurate.
There are 4 tool changes needed.
Have fun.
Bob
When you look at this file before opening it, it will look like it should be a Sketchup file. Don't try opening with Sketchup because it won't work. Just open it with whatever version of VCarve you have.
It was posted by Bill W. (I don't know his last name.) He was kind enough to share the file. He had used Aspire to design his version. I used VCarve 5.5 to make my version. I'm uploading the file in .eps format so that any version of VCarve can open it.
Because of copyright laws, I will exclude the letter "G" from the file. I don't know if this makes a difference or not because I will not sell this project anyway.
Just use your judgment when you make these and respect all copyright rules.
Also be careful when machining this project and check to see if all information and spelling is accurate.
There are 4 tool changes needed.
Have fun.
Bob
When you look at this file before opening it, it will look like it should be a Sketchup file. Don't try opening with Sketchup because it won't work. Just open it with whatever version of VCarve you have.