Upgrade Router Holder

[John 49047]

Hi Everyone,

I have one of the Mako's and like many of the post talk about the router holder loosens up. I had read on here about a aluminum upgrade holder that a gentleman by the name of Bob has information about that can be purchased for around $40 but I can not seem to find the post again, Can someone let me know how to contact him for that information.

Thank you
John

[Wolffie1]

Here you go
http://www.cncsharktalk.com/viewtopic.p ... 429#p13321
It wasn't Bob it was Ed Thorne and it is made by Sam Cheers
Wolffie

[EdThorne]

Thank you Wolffie. Bob started the project and I may have been the 1st to actually buy this clamp. It works perfectly and I am very happy with it!!!

Below are links to pictures of my clamp in use and Sam's contact information. No, I don't get a kickback.

http://www.cncsharktalk.com/viewtopic.p ... 150#p13250
http://www.cncsharktalk.com/viewtopic.p ... 160#p13321

[timlw]

Ed

I tried to e-mail Sam at the Dixiebillet.com but it comes back as invalid would you please verify that address.

Thanks
Tim

[EdThorne]

Ed

I tried to e-mail Sam at the Dixiebillet.com but it comes back as invalid would you please verify that address.

Thanks
Tim

Hi Tim,

The email address that I used is:
business@dixiebillet.com

The contact is Sam Clark.
Please let me know if you still have problems.

Regards,
Ed

[timlw]

Ed,

Just a note a note, I received my router holder today. Looks great, lines up perfect. I have to pickup
some longer bolts.

Thanks again

Tim

[EdThorne]

Ed,

Just a note a note, I received my router holder today. Looks great, lines up perfect. I have to pickup
some longer bolts.

Thanks again

Tim

That's terrific Tim. I bought all my bolts at Home Depot. Don't forget to use washers to protect the aluminum clamp body.

Good luck,
Ed