It's been awhile since I've run Cut3D with the shark.
Which post processor am I saving my tap files as?
1) cnc shark USB 3d contour (inch)
2)cnc shark USB (inch)
3) cnc shark USB arcs (inch)
I'm guessing 3d contour (inch),... but,... it's been quite some time.
Thank you for your time and help
DougE
Post Processor cut3d
Moderators: al wolford, sbk, Bob, Kayvon
Re: Post Processor cut3d
If you are doing 3d carving you use the cnc shark USB 3d contour (inch). If you are doing a 2d toolpath then use the cnc shark USB arcs (inch).
Re: Post Processor cut3d
I was just about to dig out some older files I'd done to verify...
Thank you very much Meb !
Happy new year
DougE
Thank you very much Meb !
Happy new year
DougE