Engraving on Brass Sheet Question

terryz854 · Post by **terryz854** » Wed Dec 30, 2015 1:35 pm

I want to engrave on a brass sheet that is 26mm thick. I have the Amana Tool In-Groove CNC Insert Engraving System and was wondering if when using the V-Groove blades if the router needs to be running or is the engraving done just by dragging the tip through the brass. I'll start the depth at say .001. I'm worried about snapping the point of the blade off if it drags. Any of you experience, CNC pros have any advice?

tonydude · Post by **tonydude** » Wed Dec 30, 2015 5:35 pm

You have to have the router running, only when using a diamond drag bit that you have the router off.

Tony

terryz854 · Post by **terryz854** » Thu Dec 31, 2015 10:29 am

Thanks Tony.

CNC Shark Forum

Engraving on Brass Sheet Question

Engraving on Brass Sheet Question

Re: Engraving on Brass Sheet Question

Re: Engraving on Brass Sheet Question