FS-Shark Pro Plus HD + Software & Accessories

Discussion about the CNC Shark Pro Plus HD

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
2nd Childhood
Posts: 1
Joined: Sat Feb 09, 2013 5:35 pm

FS-Shark Pro Plus HD + Software & Accessories

Post by 2nd Childhood »

I purchased this system 2 years ago at Rockler with the intent of doing something with it. Never happened. I now need the space in my shop. Here is what I am selling:
  • Shark Pro Plus HD with blue non-interlocking table that has been reinforced (see picture) plus software that came with the system
    Porter Cable model 890 router
    Touch plate
    Touch probe
    Aspire 4.0 software and license key
    Precise Bits collet set for PC router (1/8, 3/16, 1/4, 8mm & 1/2) with calibration blank & cleaner/lubricant
    10 end mill bits by Burchett 2 flutes (square bottom - three-1/8", two-1/4"; ball nose - three-1/8', two-1/4")
Aspire software can be upgraded to v5 for $400.

Original cost was over $6,500. Asking $3,495. Offers will be considered. Shipping can be arranged for an additional cost.
This system has never cut any wood, plastic or metal. It has been turned on to verify proper operation and to true the table. That is it. I have additional I can forward, if interested.
_NDF2660.jpg
_NDF2651.jpg
_NDF2669.jpg

Post Reply