Program did not complete project.

Discussion about the CNC Shark Pro Plus HD

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
SawDust913
Posts: 23
Joined: Thu Dec 29, 2011 9:19 am

Program did not complete project.

Post by SawDust913 »

Is it possible to run out of program memory in the pod controller? I got raised letters here at a z-.06 one pass with a .0625 ball. The program runs from bottom to top but stops, returns to 0 and does not turn off router, before clearing the top line. PreView looks good! Programed with V-Carve 8
Attachments
PreView-In Memory 2.jpg

Jhelfire
Posts: 2
Joined: Sun Oct 25, 2015 8:44 pm
Location: Springfield, IL
Contact:

Re: Program did not complete project.

Post by Jhelfire »

Replace the SD card from rear of Control box and install a new San Disk 8GB SD card. That fixed my problem which was the same problem that you're having.

SawDust913
Posts: 23
Joined: Thu Dec 29, 2011 9:19 am

Re: Program did not complete project.

Post by SawDust913 »

Thanks, I kind of thought that but figured the program was smart enough to say "Not Enough Memory" Or Too Large; something! I will replace the card.

Post Reply