8.5 INSTALL

Discussion about the CNC Shark Pro Plus HD

Moderators: sbk, al wolford

8.5 INSTALL

Postby gpeck » Sat Aug 06, 2016 1:06 pm

Has anyone upgraded too 8.5? I have a black diamond that for some reason the controller after turning on at the start of cutting a toolpath turned the router off
about midway of the toolpath and broke the bit because the bit was not turning. I shut down the comtroller and stated allover, I pluged the router into a wallplug and finished the tool path. I have used the toolpath before without any problem. Would like to have the router come on at the start and shut off at the end of the toolpath like it always has.. please help. thanks Gene
gpeck
 
Posts: 164
Joined: Fri Sep 06, 2013 1:35 pm

Re: 8.5 INSTALL

Postby tonydude » Sat Aug 06, 2016 6:54 pm

8.5 has nothing to do with it. You must have something wrong with the controller board, get ahold of nextwave support on Monday, they are closed on the weekend.

SUPPORT (419) 491-4520

Help Desk Support 9 a.m.-5 p.m. Monday thru Friday (EST) (419) 491-4520

Tony
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 9.510, photo vcarve, cnc mako shark extended bed, control panel 2.1
tonydude
 
Posts: 1486
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY

Re: 8.5 INSTALL

Postby gpeck » Sun Aug 07, 2016 9:53 am

Tony , I have not installed 8.5 yet. I will contact NW Monday and see what they have to say. Thanls for getting back to me
gpeck
 
Posts: 164
Joined: Fri Sep 06, 2013 1:35 pm


Return to CNC Shark Pro Plus HD

Who is online

Users browsing this forum: No registered users and 2 guests