CNCShark HD3 Randomly digs into wood - HELP!

Discussion about the CNC Shark Pro Plus HD

Moderators: sbk, al wolford

Re: CNCShark HD3 Randomly digs into wood - HELP!

Postby mwdilday » Tue Apr 10, 2018 8:24 pm

I had the same problem with the dust boot brushes being too stiff. Took a long while to figure out what the problem was. I received and installed the updated softer brush and the bristles were sucking into the dust hose connector so that isn't working. I replaced the brushes around the dust port inlet and left the other half with the soft brushes. It doesn't suck in the bristles but it was still too stiff. I cut half to the stiff bristles back and it helped but still not good enough. Wondering if the Kent dust boot is better?
mwdilday
 
Posts: 3
Joined: Sat Mar 31, 2018 8:07 pm

Re: CNCShark HD3 Randomly digs into wood - HELP!

Postby rungemach » Thu Apr 12, 2018 1:48 am

Regarding the dust boot problems, This thread has info regarding timing the bristles on an angle, so that they do not all hit at the same time.

viewtopic.php?f=2&t=4086&p=23064

This lessens the gantry flex issue when using a dust boot.

Hope this helps
Bob
rungemach
 
Posts: 447
Joined: Mon Aug 02, 2010 8:24 am
Location: Sarasota, Florida

Previous

Return to CNC Shark Pro Plus HD

Who is online

Users browsing this forum: No registered users and 1 guest