Re: CNCShark HD3 Randomly digs into wood - HELP!
Posted: Tue Apr 10, 2018 8:24 pm
I had the same problem with the dust boot brushes being too stiff. Took a long while to figure out what the problem was. I received and installed the updated softer brush and the bristles were sucking into the dust hose connector so that isn't working. I replaced the brushes around the dust port inlet and left the other half with the soft brushes. It doesn't suck in the bristles but it was still too stiff. I cut half to the stiff bristles back and it helped but still not good enough. Wondering if the Kent dust boot is better?